Table of Contents | Sections | List of Figures | List of Tables
  Capacity Analysis of Pedestrian and Bicycle Facilities:
Recommended Procedures for the "Bicycles" Chapter of the Highway Capacity Manual


6 REFERENCES

Botma, Hein, "Method to Determine Levels of Service for Bicycle Paths and Pedestrian-Bicycle Paths," Transportation Research Record 1502 , 1995.

Ferrara, Thomas C., A Study of Two-Lane Intersections and Crossings Under Combined Motor Vehicle and Bicycle Demands, Final Report, Report No. 75-5, Civil Engineering Department, University of California, Davis, December 1975.

Guide for Development of Bicycle Facilities , American Association of State Highway and Transportation Officials, Washington DC, 1991.

Harkey, D.L, D.W. Reinfurt, M. Knuiman, J. Stewart, and A. Sorton, Development of the Bicycle Compatibility Index: A Level of Service Concept, Final Report, Federal Highway Administration, Washington, DC, 1998.

Hunter, William W. and Herman F. Huang, "User Counts on Bicycle Lanes and Multi-use Trails in the United States," Transportation Research Record 1502 , 1995.

Niemeier, Debbie A., "Longitudinal Analysis of Bicycle Count Variability: Results and Modeling Implications," Journal of Transportation Engineering , Vol. 122, No. 3, May/June 1996.

Opiela, Kenneth S., Snehamay Khasnabis, and Tapan K. Datta, "Determination of the Characteristics of Bicycle Traffic at Urban Intersections," Transportation Research Record 743 , 1980.

Rouphail, N., J.E. Hummer, D.P. Allen, and J.S. Milazzo II, Research Report: Capacity Analysis of Pedestrian and Bicycle Facilities (Draft) , Federal Highway Administration, McLean, Virginia, 1997.

Transportation Research Board (TRB). Highway Capacity Manual , Special Report 209, Third Edition, National Research Council, Washington DC, 1994.

Table of Contents | Sections | List of Figures | List of Tables